Cut the JIYU ACP Panel Supplier strip from this piece


Posted August 29, 2017 by ACPkingaluc2

Cut the JIYU ACP Panel Supplier strip from this piece

 
If the side trace undergoes corrosion, the white and white residues drop, causing the surface to become rough and damaged. To solve this problem, thoroughly wipe the face with fine steel wool to dissolve the loose waste prior to washing; Allow the side groove to dry completely. Then apply a primer layer followed by an acrylic paint; Make sure the paint is applied only after the primer layer is drying out.

Replacement of the side walls
If part of the side track is severely damaged, it is not possible to replace the part with a new strip of side rail. This repair job in JIYU Matt ACP Panel Supplier is a little more difficult than we have just explained. Mark the damaged portion of the side groove with vertical lines and carefully cut the lower part of the damaged side groove and keep the top section intact with a can and tool key. Measure the size of the entire damaged component and find a replacement that is 6 centimeters more than the length of the damaged component. This causes the replacement patch with the main edge to overlap by 3 centimeters on each side. Cut the JIYU ACP Panel Supplier strip from this piece.

Apply a large amount of polyurethane caulk or silicone seal to the sides and lower edge. Similarly, it is spread over the damaged part of the side track. Now push the replacement patch into the damaged cutting area and place it under the top and bottom rows of the JIYU Nano ACP Panel .
-- END ---
Share Facebook Twitter
Print Friendly and PDF DisclaimerReport Abuse
Contact Email [email protected]
Issued By https://www.jiyu-acp.com/
Website JIYU ACP Panel Supplier
Country United States
Categories Home , Industry , Manufacturing
Tags ACP Panel
Last Updated August 29, 2017