When cracks and small holes appear on our asphalt driveways Melbourne, it becomes necessary to either hire a contractor do the sealing alone. Care should be considered when selecting the materials to use.The potholes and cracks on the driveway surfaces come about as a result of the expansion and freezing of water under the surface. Again, water penetrates the surface to settle in underground. This is the major cause of damages on asphalt driveway Melbourne. In addition, if the proper producer was not followed when installing the asphalt compound; damages are likely to occur after few days. This article explains the proper steps to be followed when sealing the driveways. It also pinpoints the importance of sealing and maintaining your Melbourne driveways.
When planning to seal asphalt driveways Melbourne, it should be done on dry or sunny weather. This implies that the sealing will never function well on wet weather. Proper preparation is expected before starting the process. Remember that asphalt driveway Melbourne sealers are corrosive therefore ensure that these products do not come into contact with your body skin. In addition, since they are hazardous, when using the sealer products, avoiding direct inhalation of its fumes.
The first step is to clean the driveway. Use the broom to sweep off dust and pieces on the surface. If there are some weeds and plants, they should be cleared. For oil and stains, use recommended detergents to clean with bristled brush. The detergents can be accessed at various stores. In case the cracks and holes are large, patching in a must. Before sealing asphalt driveways Melbourne, use patching compounds to fill all depressions available. You should follow the manufacturers’ instructions when filling large holes.
The next step of cleaning asphalt driveways Melbourne is by using the garden hose. If you decide using garden hose, wash with adequate amount of water. Alternatively, use the pressure washer which makes work easier. You should allow the washed surface to dry before proceeding to the next step. Once the surface is thoroughly dry, asphalt driveway Melbourne is ready for sealing. Before opening asphalt sealer, it is important to mix the compound by turning it upside down. Even after opening the sealer, continue stirring the compound regularly to keep it mixed.
Asphalt driveway Melbourne sealing is now ready. Start sealing from one corner to another. Always work at small area at time as this will make your work easier.It is advisable to apply two thin layers of asphalt instead of making one thick layer. Start from one end applying a thin layer, wait the first strip to dry before making another layer. Line the surface using squeegee or brush. If you not have the two, use groves to surface the area. It takes more than 24hrs in order the surface to dry. Do not drive on wet pavement as this will ruin it more. To make your surface more attractive, you either choose to decorate it with yellow or white color.

Have a chance to tour at asphaltdriveway Melbourne http://asphaltdrivewaysmelbourne.com.au/ to get useful guide. If you have a question about asphalt driveway Melbourne http://asphaltdrivewaysmelbourne.com.au/ you can always visit their website for more details.