If your budget is tight but you still want to upgrade your car audio system, you'll probably want to do it component by component. The first thing to replace with speakers, but what you have done that it's time to give them a good power signal. You do that by adding a good amplifier or two. If you're just powering front speakers, or front and rear speakers, then you'll probably only need a single audio amplifier Satılık amfi https://www.audiophile.org/ . However, if you also have a subwoofer that you want power, then you should get a separate audio amplifier just for that, and possibly even a large capacitor. There are two parameters they want to look at closely when choosing your amplifier.

The first is the power rating (measured in watts) and the other is the signal-to-noise ratio or percent THD. THD stands for total harmonic distortion, and lower the number the better. The first thing you look at his size. You determine how large your amplifier needs to be by adding up the wattage of all the speakers will be powering off the amplifier.

For example if you are powering four 50 W speakers on a single amplifier that amplifier should be rated for at least 200 W. I say "at least" here because you actually want to size it for larger them when you require. The reason for that is if you run the amplifier up near its limit consistently it will run hotter than if you run the amplifier [b]Satılık amfi[/b] towards the middle of its power rating. When the components in amplifier get hot they are more likely to introduce noise into the audio signal. And this pretty much defeats the whole purpose of getting aftermarket amplifiers begin with. However, if you don't intend to run the amplifier near capacity most of the time, you can get away with a smaller amp. Signal-to-noise ratio and THD are both numbers that use a similar process for evaluation. You'll be centrally comparing these numbers to other amplifiers in a group that you're looking at. You want signal-to-noise ratio to be high and THD to be low. The signal-to-noise ratio measures how much of a pure signal (i.e. music) you hear through your speakers versus how much static (noise) can be heard.

Obviously, you want more music than noise. You will typically pay more for amplifier that has a higher signal-to-noise ratio. This becomes more important if you listen to a lot of music that has quite spaces between passages. If you listen to a lot of death metal at high volume you might not even notice, whereas someone who listens to a lot of quiet classical music would notice right away. Total harmonic distortion is more noticeable at higher volumes. As you comparing amplifiers you want to get one that has a low THD. You can tell that an amplifier is not very good when music begins to distort as you increase the volume. That's the real-world measure of THD. Now go out and have some fun shopping for audio amplifiers müzik seti!

These are simple introduce to audio amplifier, if you want to know more about it you can come AudioPhile.org, we have all kinds of audio amplifier for sale [i]Satılık amfi[/i].