Process of repairing a flat roof


Posted July 30, 2020 by copxmartin1992

Flat roof repairs Kenilworth have specific pattern of getting them repaired, which involves several techniques as well.

 
Flat roof repairs Kenilworth have specific pattern of getting them repaired, which involves several techniques as well.
There are broadly four methods involved in repairing a flat roof.
Method 1 - Locating Roof Damage
Determine how far the leak is from the 2 closest walls. Examine the roof’s slope above the area we have measured. Most flat roofs aren’t perfectly flat. They often slope slightly to drive water off the sides. Identify any punctures, tears, or cracks in the roof. Any spot that allows water in is an immediate issue. Patching these spots will preserve the roof for longer.
Method 2 - Sealing Small Cracks and Holes
Slice open the blistered spots with a utility knife. Pop the blister first by cutting into its center. Spread a layer of roofing cement with a trowel. Push a layer of cement 1⁄8 in (0.32 cm) thick into the damaged area. Spread the cement about 6 in (15 cm) beyond the damage, and then smooth it out with the trowel. Lay a piece of fiberglass mesh over the cement, which serves as extra waterproofing. Cover the mesh with a thick layer of cement. Add a layer of gravel over the cement to prevent sun damage.
Method 3 - Applying Roof Patches
Cut out the damaged area about 1 in (2.5 cm) deep using a utility knife. Fill the hole with a layer of roofing cement. Spread out a layer of cement about 1⁄8 in (0.32 cm) thick. Coat the damaged area with a layer of roofing cement. Cut a patch to fit over the cement. Set the new patch over the original patch.
Method 4 - Resealing a Roof
Brush a bitumen primer over the whole roof. Then, get a bitumen-based primer and pour a little bit onto the roof. Use a paint roller to coat the entire roof evenly in a thin layer of primer about 1⁄2 in (1.3 cm) thick. Allow the primer to dry for at least 20 minutes. Roll a strip of fiberglass mesh over the roof. Curl the mesh ends back and hold them to the center of the roof. Mix a bitumen roof sealant until it reaches an even consistency. Paint the sealant onto the roof with a soft-bristle brush. Continue installing mesh. Add a second coating of sealant 12 hours later. Similar steps are applied for rubber roofing Kenilworth.
Website: www.jbbuildingandmaintenance.co.uk
Phone: 01926732471
Email Id: [email protected]
Address: JB Building and Maintenance, 34 Hanworth Road, Warwick, Warwickshire, CV34 5DY
-- END ---
Share Facebook Twitter
Print Friendly and PDF DisclaimerReport Abuse
Contact Email [email protected]
Issued By jbbuildingandmaintenance
Country United States
Categories Business
Tags flat roof repairs kenilworth
Last Updated July 30, 2020