The platforms are architected to enable the next phase of branch-office evolution, providing rich media collaboration and virtualization to the branch while maximizing operational cost savings. The integrated services routers generation 2 platforms are future-enabled with multi-core CPUs, support for high capacity DSPs (Digital Signal Processors) for future enhanced video capabilities, high powered service modules with improved availability, Gigabit Ethernet switching with enhanced POE, and energy monitoring and control capabilities while enhancing overall system performance.Among all [url=http://www.router-switch.com/Price-cisco-routers-cisco-router-1900-series_c16]Cisco 1900 router[/url] , [url=http://www.router-switch.com/cisco2921-sec-k9-p-161.html]cisco 2921-SEC/K9 router[/url] and [url=http://www.router-switch.com/cisco1941-sec-k9-p-150.html]Cisco 1941-SEC/K9 router[/url] are best selling models.

Following the guide to recover default password for the Cisco router:

1.You may meet two cases:
A: Can access the router, the just type show version at the prompt, and record the configuration register setting.
B: Can no longer access the router (because of a lost login or TACACS password), you can safely assume that your configuration register is set to 0x2102.

2.Turn off the router with the power switch, then turn the router back on.

3.Setting the entry point and size for the router
Press Break on the terminal keyboard a couple of times after you see the message program load complete, entry point: 0x80008000, size: 0x6fdb4c in order to put the router into ROMMON.

4.Type confreg 0x2142 at the rommon 1> prompt in order to boot from Flash.

5.Type reset at the rommon 2> prompt.

6.Type no after each setup question

7.Type enable at the Router> prompt.

8.Type configure memory or copy startup-config running-config

9.Type show running-config.

10.Type configure terminal.
The hostname(config)# prompt appears.

11.Type enable secret in order to change the enable secret password.

12.Issue the no shutdown command on every interface that you use.

13.Type config-register .

14.Press Ctrl-z or end in order to leave the configuration mode.

15.Type write memory or copy running-config startup-config

After you had done those steps, you should be able to use the password you just set to enter privileged model.