Caloosa Cooling’s Comprehensive Maintenance Service is one of the best in the business. Every Maintenance Service Includes a 35-point inspection:
- Check the Filter & Recommend Solutions as Needed
- Replace Batteries Where Applicable
- Verify Voltage at Air Handler
- Verify Amperage Draw at Heater
- Check Voltage at the Blower Motor
- Check Amperage at the Blower Motor
- Verify that an Appropriate Sized Breaker is Matched to the Heater
- Measure Return Air Temperature
- Measure Supply Air Temperature
- Clear the Drain Line
- Clean the Evaporator Coil
- Examine and Tighten Low Voltage Electrical Connections
- Examine and Tighten High Voltage Electrical Connections
- Check & Balance Proper CFM Per Ton Airflow
- Inspect Blower Wheel
- Spray Drain Pan Treatment “or” Add Drain Pan Tabs
- Check Disconnect at Air Handler
- Examine & Tighten Electrical Connections at the Disconnec
- Take Indoor Psychrometer Reading at Thermostat
- Verify Filter & MERV Rating if Static Pressure is High
- Examine Duct-Work for Visual Issues
- Remove All Existing Debris Near Air Handler
- Record Maintenance Details on PM Sticker
- Collect Air Handler Data
- Label Unit if it is Currently Unlabeled
- Remove Debris from Inside Exterior Condenser Unit
- Surface Clean the Condensing Unit Coil
- Take Refrigerant Pressure Reading
- Take Subcool Reading
- Take Superheat Reading
- Take Voltage Reading at the Compressor
- Take Amperage Reading at the Compressor
- Apply AC Service Contact Information
- Check Breaker Panel Labeling
- Check Breaker Panel Amperage Sizing