There are not only many different types of doors in our lives, but also a very commonly used type called hard fast doors. When installing a hard fast door, a series of wiring adjustments are required. After the hard fast door can reach a specific part when in use, the installation work of the hard fast door is declared complete. Next, follow the editor of Bast Intelligence Equipment to learn about the parts of the hard fast door wiring debugging work.

1. The route is the core area where each component of the hard fast door is connected to each other. The wiring position refers to the imitation sheet, and is generally marked. Therefore, before wiring the hard fast door, you should read the product introduction carefully. Especially for the wiring diagram of the terminal block, master the function and wiring regulations of the terminal block at each connection point, so as to facilitate the subsequent wiring work.

2. After connecting the hard fast door to the switching power supply, check whether the fault indicator is flashing. If the display light is on and accompanied by an alarm sound, it indicates that the hard fast door switching power supply is contradictory and the wiring is incorrect, and the three-phase power supply should be adjusted. Enter the line and check the route of the power supply system.


3. Manual operation inspection: Press the up button, the door page of the hard fast door will rise to the top quickly; activate the light down button, the door will quickly drop to the bottom; when the hard fast door is operating or stationary , Press and hold the emergency stop switch, the hard fast door will immediately stop at the origin and no longer operate. If you want to continue using it, just turn off the emergency stop switch and you can resume normal use.

3. Check the safety photoelectric switch of the hard fast door. If the light source is blocked by the roadblock during the whole process of lowering the door leaf, the hard fast door will immediately rise up slowly.


Hard fast doors are a variety of products in modern factories and enterprises. Using this door type, each time the door is opened and closed, the company can save about 80% of energy consumption. With the continuous maturity of product technology, hard fast doors are in Europe and the United States. Industrial plants are widely used, convenient to use, easy to operate, reliable, and beautiful in appearance. The design, production and installation cycle has been greatly shortened, and the work efficiency has been greatly improved. At the same time, it is particularly important for the commissioning and acceptance of the fast door after installation.

In general, the hard fast door wiring debugging work is divided into two steps, accurate wiring and checking the power switch. Although these two steps seem easy, it is difficult to be foolproof. But for safety, you must not be lazy when doing installation work of the hard fast door. When installing hard fast doors, every step needs to be carried out carefully. The above is right, the detailed introduction of the hard fast door wiring debugging, I hope it will help you better understand the hard fast door.


Service hotline: 19952701625

Contact: YEYINGYING

FAX:19952701625

Email: [email protected]

Address: 10#Hongxiang Road, Hudi Town, Binhu District, Wuxi