Installing a car DVD player has much benefits. You can enjoy yourself on road. Deciding to install an overhead DVD system can be rewarding in the long run. You can find an auto shop and install the head unit. You can also install Android Car GPS by yourself to save money. A novice can complete this type of project, but some experience in this subject will make the process go more quickly. Take your time and it will pay off on those long family travel trips.

Partially drop the headliner of the vehicle. Only one side of the headliner needs to be dropped just enough to bring the wires through. Unscrew the driver's side or the passenger side sun visor that the fuse box is located on. Disconnect the vanity light by gently pulling the connectors. Pry off the upper and lower pillar trim panel on the same side from which you removed the sun visor with the flathead screwdriver. You may need to remove the seat belt if it is attached to the upper pillar. The seat belt is usually secured with a head or Torx bolt. Remove any screws and retaining clips. Unscrew the kick panel over the fuse box and place the panel to the side.
Connect the power and audio wires on Android Car GPS as detailed in the manufacturer's instructions. All wires must be connected to a 12-volt source except the black one. It must be grounded. You can use any screw to ground the black wire. Use the wire crimper to cut the wires and use the electrical tape to secure wire connections. Place the FM modulator under the seat nearest to where you took off the panels.

Each car model has a slightly different installation process. However, these general guidelines apply to any car capable of supporting this device.
First, open the hood. Locate the car battery. Car batteries all have two metal clamps connected to them. Next, you need to remove the old or original factory car stereo unit. First locate the vehicle service/repair manual or consult with a local professional for proper instructions. Note that removing the original stereo system might require special tools and could be difficult for beginners because it’s necessary to disassemble some parts of the dash panel. Pull out the unit and disconnect the cables.
Make sure to distinguish the anode and the cathode when connecting the power. For secure package transportation the CD/DVD reader module is firmly fixed with a screw. Before the installations of the unit, please remove the screws from the top. If the screws are not removed, you cannot insert any CD/DVD disk.

Eonon is the best online shop to buy the steady high-quality car DVD player. GM navigation and Android Car GPS are our hot sale. Eonon is very popular around the world with great fame in both amazing products and good after sale service.