Using high-quality batteries and being mindful of what voltage they should be charged at will greatly reduce instances of e-cigarettes exploding in your pocket.

However, some numb nuts like to see the world burn. There are vape modders who like to use “unregulated” mods for vaping. These mods are ridiculously simple to use, but if the set up isn’t perfect the battery can overheat and, again, thermal runaway.

Unless you are an expert in electrical engineering it’s probably better to stick to regulated mods.

Why is it called modding?

In the beginning vaping was done exclusively through egos, but brave vapers said “we can make these battery packs better” and began to mod them. It eventually spun off into its own subset of vaping, and while most mods are now bulk manufactured, the name has stuck around. They’re popular because they’re incredibly customizable.

What the hell is a mod vape?

Mod vapes are the Vaping Products in United Kingdom with the most passionate following, they’re also the most difficult to get into, and they are made up of a few primary components:

Battery Mod: This is the box at the bottom. Depending on the mod it can hold up to three batteries—the traditional being a 16850 rechargable battery. Temperature, wattage, ohms, and volts may all be reported/controlled here.

Tank: This holds your e-juice. They can start out very small—some only hold a couple of mL—and they can get very big. I’ve seen tanks that hold over 10mL.

Wick: If you heat the e-juice directly, you will have a potentially unpleasant experience. Wicks absorb the e-juice and carry it to the heating element. They can be made of a lot of different substances though cotton and silica are the two most common.

Coil: The heating element. It comes in a variety of resistances starting as low at .2 ohm and going up above 1.8 ohm. While some vapers will build their own coil and wick, they are usually purchased together and can be found under the term “replacement coil.”

Drip Tip or Mouthpiece: The tip that you smoke out of. There are a lot of tips out there and they’re made of a lot of substances: from pyrex to glass to steel to simple plastic.

Atomizer: Many people (me) don’t want to fuss with finding a specific coil, wick, tank and drip tip. Atomizers are all four components sold together. To get to vaping you screw your atomizer into you battery mod, fill up the tank, and puff away.

About the Company :- Vaping Solutions happens to be one of the most important companies in UK offering the best vape products for recreational use. With high popularity, the company is increasing in its demand and supply.