Sport High Power E-Bike Supplier Introduces Battery Maintenance Requirements


Posted November 18, 2020 by taizhousuqier

According to Sport High Power E-Bike Supplier, lead-acid batteries without a battery box will not "explode", but the reason why the battery will "explode" after being installed in the battery box is that:

 
According to Sport High Power E-Bike Supplier, lead-acid batteries without a battery box will not "explode", but the reason why the battery will "explode" after being installed in the battery box is that:

1. The power supply box is too sealed, and the hydrogen produced at the end of the battery charging cannot escape;

2. The power connection line is loose, aging, or exposed, sparks are generated when the key is turned on, or the line generates sparks to ignite hydrogen due to uneven road vibration;

3. The fuse holder on the power box body is loose, and it generates heat or sparks during the charging and discharging of the battery, ignites the hydrogen gas, and generates gas expansion, which breaks through the battery cover.

Preventive measures:

1. The power box body should not be too sealed when designing, and several convection vents with a diameter of about 1cm should be set on the upper and lower parts of the battery box to facilitate the discharge of gas generated during charging;

2. If the power box is designed without ventilation holes, ventilation holes must be reserved during installation;

3. Regularly check the power wiring to prevent looseness, aging, or exposure;

4. If the fuse holder is found to be loose and aging, replace it in time.


Through the above introduction, Electric Vehicle Manufacturers hopes that you can simply refer to the content of this article in future use.
-- END ---
Share Facebook Twitter
Print Friendly and PDF DisclaimerReport Abuse
Contact Email [email protected]
Issued By taizhousuqier
Country China
Categories Accounting , Affiliate Program , Architecture
Last Updated November 18, 2020