If you discover what you suspect might be mold growth in your home whether it is within the walls of your bedroom, in the basement or the crawl area of your home or even in your closet it is always wise to identify the kind of mold before attempting any kind of clean up.

Why? Well, some conforms are pretty harmless, maybe causing some minor allergic reactions such as itchy eyes, headaches or irritating some current illness such as asthma. Others, can be dangerously toxic and really should only be cleaned up by professionals.

To enable you to determine shape types in your home there are an array of different home mold tests kits on the market. As ever the choice can be confusing with certain packages designed for a specific type of test.

So , in an effort to help you choose what kind of mold testing kit you should purchase shown here are some different types of kit and an explanation of their uses.

one The Lift Tape Kit

This kind of kit is perfect in case you are already certain that the staining you have found is undoubtedly fungal but still need to identify the type. It can be used to test often the surfaces of floors, walls, ceilings, furniture and so forth.

This particular testing kit could not be easier to use, simply peel back again the tape from the tacky surface and press the exact sticky side of the tape gently onto the mould surface. Then, simply replace the covering over the sticky surface area and take it off for laboratory testing.

Remember - you will need to use one kit per surface.

2 . The Instant Package

This testing kit will confirm immediately - nicely, in about 10 minutes to be more accurate - if the growth you are concerned about is definitely mold. What it does not inform you is the actual type of mold, you will still require lab analysis to determine whether it is toxic and/or potentially damaging to be able to health.

Once again this mold kit is extremely simple to use. Take away the swab out of the tube - make sure you don't touch the finish of the swab. Swab the suspect area and then placed the swab back in the tube. Shake the test tube and keep for approximately 10 minutes then check the color against the color graph which is provided in the kit.

With this kit also you will require a new one for each area you need to test.

3. The Practical Kit.

The Viable mold test kit is probably the one that has most uses for a mold testing kit which doesn't need laboratory analysis.

This kit can be used to establish whether there is certainly mold present and also the strain of mold. You can also to make use of it in testing the air quality of your property and also the heating system.

This mold kit consists of a Petri dish along with gel in it and a swab. To carry out the test simply clean the suspected mold then rub the swap on the gel in the dish, replace the lid and allow it for you to germinate for a few of days - usually anything through 3 to 7 days.

If you wish to use it to test the air high quality of a room you will require 2 mold test kits. Eliminate lids off both - place one in the room and the 2nd should be placed outside but still close to the room you are examining.

Leave the kits in place for about one hour before replacing the very lids. In approximately 7 days you should have some mold development.

Next, compare the results. If both produce the same pressures of mold growth then the mold found in your space is merely representative of what is found in the general environment. If variations are found and the Petri dish from the room is showing additional or different strains of mold growth that is definitely wise to have it checked out at a laboratory.

To check your home heating, close all vents with the exception of one which is furthest from the heating/cooling system open. Switch on the system on the optimum setting for around 10 minutes with the mold test kit attached with the open vent. Once the 10 minutes is up close the main dish and again allow it to sit for 7 days maximum.

Some caution - if you discover that there is significant mold growth within the Petri dish used to test the heating/cooling system it might be sensible to have it properly checked out at a laboratory.

visit: moldtestusa.com/