China – Although the using process of the Heat Shrinkable Tube and sleeve is very easy and convenient, there are also many factors which people need to pay more attention. Now, in order to let more and more consumers know these factors, the engineer from famous China heat shrink tube manufacturer Shenzhen Dicore will introduce with people these attentively points.

First, the operator need to remove burrs and sharply points electrical wires. The clean surface of the wire could help to prevent the cracking and piercing in the retraction process of heat shrink tubing. On the other hand, before using heat shrink tubing, the better cleaning for oil on the wires by fast-drying agent should also be very necessary. Only in that way the heat shrinkable sleeve could be better stick on the broken wires part.

Secondly, before the sticking of Non-Slip Heat Shrink Tubing , Cutting process for the heat shrink tube should be necessary part as the applying part for the shrink tube has different size. In the cutting process for the shrink tube, the incision should be neat and smooth without any burrs or cracks. This could avoid the break generated by heat shrinkage stress which spread along the gap of the tube. The heat methods for these heating shrinkable tubes could be varied which main methods are temperature oven, propane lights, gas fire, gasoline blowtorch and industrial electric air gun.

Thirdly, when people use industrial hair dryer or liquefied gas gun to shrink the tube, the operator must heat the tube uniformly from one end to the other end or from the middle to both ends. However, people must not heat the heat shrink tube from two ends to the middle of the tube. On the other hand, if people use a heat gun which the general temperature is from 4000 degrees to 6000 degrees and a variety of tools which could produce the blue flame which temperature is more than 800 degrees, people need to pay more attention to the distance between fire and heat shrink tubing. The angle between the out flame and the surface of heat shrink tubing should be 45 angles and people should heat the tube with moving and they should not let the fire become too close to the surface of the sleeve or centralized heating in one place or it will cause uneven thickness or burns sleeve.

After the shrinking process, people need to put the finished part on clean and soft platform to prevent scratching www.dicoretubing.com . This finished part should be trimmed after cooling. For curved part of the wire, people need to carefully organize the curved shrink tube and prevent wrinkles of the surface of it.

About Shenzhen Dicore Technology Co., Ltd

We are the professional and Reliable One-Stop Supplier of various heat shrink tubing from China. With full products range of selection to fit different demands from the field of Energy, Electronic, Automotive, Communications, Military, and Building, ship building and others

Contact:
Shenzhen Dicore Technology Co., Ltd
#Address: B, Floor 5, Building F, ShiFeng Technology Park,
Lou Cun Second Industry District, GongMing,
Shenzhen, China, 518107
Tel: 86-755-61653518
FAX: 86-755-61653519
E-mail: [email protected]
Linkedin: http://www.linkedin.com/pub/bob-liu/26/230/490
Website: www.dicoretubing.com