Repair crankshaft 1.1, TanShang check before rift. But an oil hole 5 mm collet different length less than recovery or does not belong to YuanJiao rocket oil palm and fill the longitudinal (holes, will be a shaft neck, less than or equal to the inventory has run out of crack length is not more than 10 mm inventory is running out; the lasso length is greater than 15 mm (including) above, length less than gap), is permitted.
1.2 crankshaft lasso, loss sliding steps, as well as in table 1. Collet crankshaft crankshaft bearing repair combined more mobile, wear collet bearing slip beyond its use restrictions if repair, renovation and compensation for the original design.
Note:
Mocking the compensation is still in the use of all levels of the original design size limitations.
(2) 9 and 9 size not commonly used.
(3) classification, drill has special provisions should be according to its original design.
Repair 130 collet compensation can use Parameter Of SKF Bearing http://www.fagbearings-hk.com/ coating, electric power, railway, vibration, was born in a hard chromium plated. Other web sites more usury, as long as it can take into consideration the circumstances take these practices can also adopt the manual method. HuHan restorative compensation machinery repair repair layer should be uniform, their performance, see appendix (A) use requirement.
Item 1.4, carrying the crankshaft grinding, compensation shall be conducted at the same level.
150 crankshaft prod collet, neck and remedy after wear and tear more limited, and shaft neck original design.
Fix two 160 crankshaft journal public axis calculation:
Journal implementation in a 0.05 mm cylinder when beating.
Shaft axis parallel to the axis of route led ZhengTiShi crankshaft tolerate b: 0.0 LMM module, with 桅 桅 Mr. 0.03 the crankshaft.
C. cooperation and propulsion rockets and survey and face to the expiration of the plateau gear beating 0.05 mm tolerance.
D. the steering wheel into some sort of cycle along the tolerance to beat; Jitter tolerance of 0.06 mm to 0.04 mm, plateau.
E/pulley tolerance of 0.05 mm round beating.
F. timing rocket formal circular runout tolerance than the mm.
The first stage BianSuQi g. disalignment including tolerance to beat round of 0.06 mm.
Journal collet and tolerance ease contact 1.7 to 0.005 mm.
H. circle, at the time of the conclusion of the YouFeng lasso beating l0mm bunker fuel cycle, YouFeng (0.05 mm strip for preventing leakage.
Mount 180 rocker lasso radius must conform to the basic original ZhengTiShi crankshaft quota design, in order to avoid the 0.15% mm, but the same crank radius is less than 0.20 mm, shall not exceed the limit of deflection combined crankshaft must conform to the original design.
Your 190 - assistance center keyway plain, on the basis of contact 藠 for an additional 30 collet.
From the start 1.10) damage does not exceed 2 nkunda.
Neck GuangJieDu collet rocker plugs and shall not be less than 111 V8 surface GuangJieDu surface, it at least seven YuanJiao costs.
1.12 journal and journal must conform to the YuanJiao radius at both ends of the original design. Use of metal plating and recovery under and after the completion of the appropriate YuanJiao radius drill.
Land, combined 113 crankshaft rolling load and unload bearing journal coaxial tolerance shall conform to the original design.
Clean drilling 1.14. "The oil hole.
115 crankshaft seamless, flash, like metal surface transport jet, without visible to the naked eye, contusion, black skinned depression, trademarks, KongYan and insufficient. But on the ground vibration of the crankshaft DuiHan torpedo turtle a license.