You might often change waste toner bottles or install a new toner cartridge to shook a bit harder. After that, you also eye-witnessed a massive mess on your shoes, hands, shirt, floor, and on the copier. It seems a daunting task but if you take it accurately it will never repeat.
However, before moving further always remember heat is not your friend while we talk about toner, except printing time. Only in printing toner fuses to paper by heat and it’s the heat that also fuses the toner to your cloth or skin. Therefore, never think of using hot water and just use cold water.

Today we will highlight discuss the top 7 ways to clean up laser toner spills.

1. Toner is an exceptionally fine powder that you must now want to breathe and get all-around your body. Therefore, while handling any cleaning project, always take ESD safe toner Vacuum, wear disposable gloves and a paper facemask.

2. If you are carrying a huge amount of loose toner, then scoop it up for placing inside your bag and seal it. It might be thrown out in the dustbin, but you should know whether your local area’s rules permit it to dispose of or not.

3. Take a paper towel along with the ESD safe toner Vacuum, wet that paper with cool water then wipe down its surface at that spill site.

4. If you have any toner for fabric or clothing, still take a facemask along with carrying essential items outside on a trashcan. If there is any toner remain, you can toss that item into a clothes washer, but ensure the machine should run on cold because the toner might get melt soon.

5. If there is any toner remain on the floor or over another surface then you can use ESD safe toner vacuum cleaner. Again make sure the vacuum’s filters can hoist toner without spreading this fine powder in the air.
6. If you can see any toner on a carpet, then dampen a clean towel that contains cleaning fluid and drop up the toner with it. Remember you do not need to use any water because it can make a stain mark on that carpet.

7. Check everything if your copier consists of a cleaning cycle. If it has then you should start it for eliminating loose powder in the piece of tool. Apart from that, you can also run 10 or 20 copies and that must clean this up.

Website- https://www.henchman.com.au