Australia

The simplest and safest way of getting more power out of your bike is dyno tuning. One might wonder that only bolting on the parts the entire day or strapping the car for a few hours will do the job, but that's not true. The dyno has been designed to simulate consistent bike riding and monitor horsepower based on RPM and torque. It helps in the optimisation of the performance of your vehicle. However, it would help if you considered a few things before sending your car for the dyno tune process to check its optimal condition.

Boost leaks

Boost leaks are found between the turbocharger's compressor outlet and the engine's head or in-piping, leading to the wastage of measured air. This leak will lead to a lack of boost pressure, costing you more power and also cause bikes to run dangerously. If the ECU is set up correctly, then the bike can run safely and efficiently. So it is essential to take a vacuum or boost leak tear before you give your vehicle for dyno tuning.

Leaks at the in-take

It will be impossible to calibrate your bike if it has a pre-turbo leakage. The vacuum that will be created because of the leakage will lead to constant sucking of air. This condition will adversely affect the wide-open throttle and part throttle. So it is necessary to check your engine before giving the vehicle for calibration at the motorcycle service in Brisbane.

Leaks at exhaust systems

Leakage at the exhaust system can lead to scavenging issues and back pressure on naturally aspirated vehicles and cause inaccurate readings in turbocharged motorbikes. This will cost you time and more money if you don't test your vehicle before giving it to the dyno tune process. There could be various calibration problems that could halt tuning.

These are the few factors that need to be taken care of before giving your vehicle for dyno tuning at the motorbike services in Brisbane. Various services can guide you through the process of dyno tuning and other necessary procedures for the optimal and smooth working of your vehicle.

For more information, Visit our website https://www.hdm.com.au/