Injection operator processing requirements


Posted January 13, 2015 by cnmoulding

CN-moulding is a mould maker and plastic injection molding factory in shanghai china, specializing in high-quality custom injection mold and plastic injection molding products –company,manufacturer,suppliers

 
Injection operator processing requirements
A, plastic product quality requirements
1, the injection forming of product, must ensure that the product structure is complete, there is no less material, more material phenomena.
2, product surface bright, uniform chromaticity, full.
3, product surface is not filled with flowers, impurities, defects such as black spots.
4, the product shape neat, there is no deformation, distortion, and the internal products are obvious bubble phenomenon.
5, the product can cooperate with relevant parts is normal, without external force cannot be separated.
6, the assembled product to need, after assembling the operators need to introspection, to ensure that products meet quality requirements. There is no
Not installed in place, packing, and have a fracture phenomenon.

Second, the plastic products trimming
1, the product of the inlet with trimming knife cutting, cutting mouth who can not have express white appearance.
2, when trimming knife trimming, forcibly when repairing products shall repair products outside introversion, resistance force direction is not allowed to have another hand
Block.
3, product trim on the handle of the strength should be uniform, can guarantee a hard cut products as much as possible, long group of front, middle
Not stagnation, a fix to the end, to ensure that after trimming the edges of the beautiful appearance.
4, the surface of the product by trimming does not allow defects wavy lines and uneven.
5, to remove the inlet area, trimming should level off, allow the phi 10 from minor scratches, trimming to improper
Other parts are not allowed to have should be trimming undeserved cause scratch defect.
6, to put front height is greater than 0.2 mm should be handled for trimming (unless adjust injection parameters to solve), especially in the production
Product outline on the edge of the phi front must be removed.
7, for different products, it is suggested that should use different types of trimming knife, to ensure product quality, improve the efficiency of trimming. 8, don't allow should trim other qualified on the surface of the damage caused by improper operation (such as good surface scratch, cut, etc.).

Three, product storage and handling
1, product stacked on the pallet height should not exceed 1.2 mm, the number of the same specifications each building products must be the same, with winding mode finally. For small products in the turnover box, bottom in turnover box height should be 10 cm, turnover box the loading weight of not more than 25 kg.
-- END ---
Share Facebook Twitter
Print Friendly and PDF DisclaimerReport Abuse
Contact Email [email protected]
Issued By shanghai CNMOULDING TECHNIC CO,.LTD
Website www.plastic-injectionmoulding.com
Phone 8602152913487
Country China
Categories Industry , Manufacturing
Tags china mold maker , china mold manufactory , china mold supplier , china mould , china mould factory , china , plastic injection , mold manufactory , plastic injection molding
Last Updated January 13, 2015