Apart bearing experts to teach you


Posted December 21, 2013 by bearing

Needle Roller Bearing、Angular Contact Ball Bearing、Cylindrical Roller Bearing、Thrust Roller Bearing.Today Let us talk about Apart bearing experts to teach you.

 
AOBOTE Bearing Transmission Technology Co.,Ltd.is one of the authorized bearing agent to sell self-aligning ball bearing from AOBOTE http://www.fagbearing-china.com/FAG-Self-Aligning-Ball-Bearing/ and other world famous branded bearingNTN,NSK,KOYO,SKF,FAG,Timken and the other.With more than 30 years selling experience and a wide range of products in stock,AOBOTE Bearing have sell well throughout the world and wined a good reputation from most of them.Except that Our company are also dealing with Deep Groove Ball Bearing、Taper Roller Bearings、Spherical Roller Bearing、Needle Roller Bearing、Angular Contact Ball Bearing、Cylindrical Roller Bearing、Thrust Roller Bearing.Today Let us talk about Apart bearing experts to teach you.

Under the direction of car machine bearings, it is a small corner, when bearing retainer fall apart, ball converge to one side. When open it replace bearing inner sleeve and the coat is not a body. At this time, to stay in the small

corner, only the coat of the bearing. To remove it, that is difficult, why can't laid hands on him!
The principle of application of this method is that the choice of iron, depends on the bearing outer ring diameter of bore flexible. When the bearing outer ring of the inner hole diameter, the greater the iron bar, of course, the more

the more wide thick. (note that also adjust screw screw holes) at the same time, also need to adjust, is in accordance with the bearing outer ring of the inner hole diameter flexible plate length. Don't lose this little device in use

after, can use for a long time.
Here, let me tell you a trick:
1. Measured with vernier caliper and the inner hole diameter of the bearing coat, for example, is 60 mm.
2. Saw a piece of about 20 mm wide, about 5 mm thick, iron plate is about 70 mm long.
3. In the middle of the plate, a "center"
4. In order to "center" as the center of the circle, with round planning a 58 mm diameter of the original curve.
5. On the grinder, put the spare parts other than the original curve according to the original curves trimming.
6. Bend iron hammer, hammer (note that camber wants even using vernier calipers measurement hammer after bending plate length, the size of 60.5 MM.
7. On the "center", use 5 mm drill into a hole. Using M6 screw tap set button.
8. Find a tong long buckle the M6 screw from the concave surface of the iron bar of twist in just outcrop (can)
9. It is convex in the direction of the small firm pressure into the ball groove of bearing outer ring.
10. The long screw to tighten the direction of rotation, at this point, in the narrow direction bearing coat will behave yourself out!
-- END ---
Share Facebook Twitter
Print Friendly and PDF DisclaimerReport Abuse
Contact Email [email protected]
Issued By /bearing from Fag
Website self-aligning ball bearing from AOBOTE
Country China
Categories Business
Tags bearing from fag , aobote bearing , selfaligning ball bearing from aobote
Last Updated December 21, 2013